- : 0086-21-61182423
- : 0086-21-61182425
- : [email protected]
- : Room 301,Unit 6,lane 2500,xiupu Road,Kangqiao Industrial Area,Pudong New District,Shanghai
- Improper welding of X80 pipeline may cause cracks
- Brief introduction of API X52 pipeline steel
- The difference between PSL1 and PSL2
- Harm of inclusions in X70 pipeline steel
- API 5L pipeline pipe
- X52 steel plate surface quality standards that need to be met
- The basic production process of API 5L X60 pipeline steel
- The key to Q460D steel welding process
- What does the heat treatment of Q690 Steel include?
- Reasons for choosing Q690D steel
CCS EH36 Z35 plate technical requirements
CCS EH36 Z35 plate is high strength ship plate, E is the quality grade E, H means high strength building material, 36 is the maximum compressive strength, Z is the Z-direction tensile.
CCS EH36 Z35 plate technical requirements:
CCS EH36 Z35 plate is for offshore platform. It shall meet Z-direction performance. According to the requirements of GB5313, the sulfur content of CCS EH36 Z35 plate is not more than 0.005%.
In order to obtain good low temperature toughness and weldability, it is necessary to refine and even the grains in the whole cross section and thickness direction of the CCS EH36 Z35 plate. Measures for grain refinement and uniformity: on the one hand, in the control of rolling process, the reduction amount and rolling speed of each pass should be reasonably designed. When rolling in the austenite recrystallization zone, the single pass reduction shall be increased as much as possible: when rolling in the austenite non recrystallization zone, the larger cumulative deformation rate (≥ 60%) shall be ensured, and after rolling, the rapid cooling shall be carried out to control the grain size in the rolling state. On the other hand, proper normalizing process can further refine the grains and make them uniform.